Questions tagged [frontier]
15 questions
5
votes
1 answer
Drain Plug Crush Washer- Installed wrong size
Nissan Frontier 2018 4.0L. SV
Parts store said I could use any washer in an assorted pack of washers labeled M14. Upon looking further into issue I found that a M12 is the correct size. I already installed the M14. It is not leaking now. Will that…
steve lay
- 51
- 1
5
votes
2 answers
RPM wildly fluctuates while idling
Recently replaced the EGR valve, a bunch of vacuum hoses, and removed & cleaned the throttle body on my 2000 Nissan Frontier (manual transmission). The entire vacuum system was clogged with carbon due to the EGRC-BPT valve leaking exhaust…
x0a
- 299
- 1
- 4
- 8
2
votes
1 answer
Car dies suddenly power at all
Today I was driving my BF's 2003 Nissan Frontier when suddenly it dies. No power, everything died. No hazard lights either. I tried popping the clutch to get it started and nothing.
I parked it in median and raised the hood. The battery was just…
Sadfrontier
- 21
- 2
2
votes
1 answer
voltage starts at 14 every morning but then drops below 12 shortly after driving
Just bought a 1998 Nissan Frontier. It has a new alternator. For a while I was getting shorts at the terminal connectors so I replaced both. That seemed to fix the short but then I started having trouble cranking up in the morning because the…
user53360
- 23
- 3
2
votes
0 answers
2004 Nissan Frontier V6 2WD Radiator Fan Clutch Removal
How do I remove/install the radiator fan clutch from the top or the bottom of a 2004 Nissan Frontier V6 2WD?
Chris
- 21
- 1
1
vote
0 answers
Should 7.5A "Air Con" circuit draw amps while vehicle is off?
I believe that my truck (1999 Nissan Frontier SE 3.6L) has a parasitic draw issue.
Was going through the fuse box checking voltage, the "Audio" 15A circuit had full voltage, which I believe is normal and okay as the circuit stays live to power the…
Tyler N
- 169
- 4
1
vote
2 answers
Exhaust rusting
I just purchased a 2023 nissan frontier pro 4x new back in the end of December. I live in the northeast, so I know rust will happen on the exhaust and muffler quickly. This just seems a bit excessive since my dad has a new frontier he bought about 8…
Samo23
- 11
- 2
1
vote
1 answer
Left Parking Brake On
I recently bought a new vehicle (2019 Nissan Frontier) and I guess because I was not used to it I left the parking brake on and drove for about 6 km (3.7 miles) at about 50 to 60 km/h (31 to 37 mph). I noticed something was wrong when I heard a…
Bartitsu Master
- 11
- 3
1
vote
1 answer
Is the Nissan V-6, 3L , of 2003 , an interference engine?
A friend has Frontier with this engine and a mechanic told her the timing belt broke ( 160,000 miles). He just said it would be expensive to fix. To try to get a more detailed idea of how expensive , I am wondering if her 2003 Nissan V-6 ,3 L , (…
blacksmith37
- 3,743
- 1
- 10
- 15
1
vote
2 answers
how to deal with yokohama 215 45 r18 tier side wall damage
I think the damage is this part, should i replace it?
Jerome
- 111
- 2
1
vote
0 answers
Clutch pedal is sticking and will not go down all the way on a 1994 nissan frontier truck
The clutch pedal on my 1994 Nissan Frontier will only go down about one quarter of the entire throw. I can put the shifter in gear but its like I still have the clutch pushed in. I can shift into any gear without touching the clutch.
Wayne Smith
- 11
- 1
0
votes
1 answer
Car turns over strong and runs fine but struggles to start
my 2000 nissan frontier v6 will run fine, but it struggles to turn on unless I step on the gas pedal and pump at it a bit while starting the car. on a second attempt to start the car, it often will start without giving it a little bit of gas. I am…
Oscar
- 68
- 5
0
votes
1 answer
Can I bypass my transmission speed sensor and install a different type?
I'm working on a 1998 Nissan Frontier XE King cab automatic transmission 2 wd
The vehicle speed sensor (vss) is located on the side of the transmission near the back. It has a two prong electrical connector. The old one was really difficult to get…
hermancain
- 101
- 2
0
votes
0 answers
Having trouble restarting the engine after stalling it while learning to drive manual
I'm learning to drive a manual in a 2010 Frontier SE KC, with a 4.0 and a 6-speed. It has 61k miles. As expected, there's a learning curve to driving stick, and I occasionally find myself killing the engine at launch, sometimes more than once before…
nerdenator
- 111
- 3
0
votes
1 answer
Nissan truck overheats sometimes
if on a 2004 Nissan frontier ,the water at normal temp.and you have the cap off on the radiator should it be flow water through the radiator if everything working properly.
