Questions tagged [sandero]
5 questions
5
votes
1 answer
Is it safe to start the engine after rotating crankshaft by hand(using a torque-wrench)?
A quick question before I start my engine.
On a renault sandero (K7m), I took the timing-belt cover off to inspect the condition of my timing-belt.
I then rotated the crankshaft until I could get a better idea of the condition of the…
Jim
- 461
- 4
- 11
1
vote
1 answer
Why, when rotating the crank-shaft manually, with the spark-plugs removed, is there still some resistance?
K7M engine (Renault Sandero)
I have recently replaced the timing-belt and tensioner. This is a first time for me, doing this job.
The marks are lining up and I'm about ready to put everything back together. But I have a concern that I'm hoping I can…
Jim
- 461
- 4
- 11
1
vote
1 answer
Is it necessary or advisable to remove the spark-plugs prior to rotating the crankshaft by hand?
K7m Engine(renault sandero)
I tried rotating the crankshaft by hand(for alignment purposes during a timing-belt change) and it does move but it's a bit on the stiff side and I'm worried about the main crank pulley bolt moving independently of the…
Jim
- 461
- 4
- 11
0
votes
1 answer
Dacia sandero rust
Hi everyone who is reading this. I have a white Dacia Sandero 2015 with around 56k miles on the clock. I believe it needs a new clutch but after looking under the bonnet I am a bit concerned about the rust under here. Some advice would be useful :).…
0
votes
1 answer
Hydraulic jack mount point on np200/sandero(K7M engine): see pic
I'm not sure if this is the correct jack point. I have it under the front bolt on what looks to be a centre frame point between the two front wheels. But there is also one a little further back.
Please confirm the correct hydraulic jack mounting…
Jim
- 461
- 4
- 11