Questions tagged [land-cruiser]

A model of car manufactured by Toyota

13 questions
5
votes
1 answer

5th Gear slipping out when letting off gas pedal in Toyota Landcruiser HJ75 - 1990)

Whilst driving, when I take my foot off the accelerator in 5th gear, the stick/vehicle goes into neutral. It's doing this more and more. Any thoughts?
4
votes
1 answer

Reversed the battery terminals - What damage have I done?

I inter-switched my battery wires, positive to negative. Now the car moves but does not accelerate, even with the pedal to the floor. What damage have I done by reversing the battery terminals? The car is a 2006 Toyota Land Cruiser V8.
joseph
  • 41
  • 1
  • 3
2
votes
3 answers

Can I increase the wattage of my landcruiser plug?

I have a landcruiser / prado (2020) in Europe with a plug in the back that has 220V and 150W. Can I somehow increase this wattage to 800-1000W so I can plug in a spot removal machine? My car has 2 batteries, so I feel like it should be able to…
user1721135
  • 291
  • 6
  • 11
2
votes
1 answer

Car pulls left, rattles very hard, steering wheel not straight when going straight

I recently noticed several problems with my 2019 Diesel Land cruiser J150 (called Prado elsewhere): When I go straight and let go of the steering it goes left fairly hard, have to constantly apply pressure to keep it centered When I am going…
user1721135
  • 291
  • 6
  • 11
2
votes
3 answers

Land Cruiser did not pass emissions

I have a 2002 Toyota Land Cruiser that did not pass the smog test because my catalytic converter needs data. My battery was changed two month ago. How can this get fixed?
2
votes
0 answers

Toyota prado 2015 map disk error

I see this in Toyota Prado Land Cruiser 2015 Which in english it says: Unable to load program please consult your dealer. How can I (preferably DIY) solve this? Additional Photo incase you need more info about the system:
YulePale
  • 121
  • 2
1
vote
1 answer

Is there a way to stabilize a large crack in the windshield until I get the car home to its insurance?

I have a crack in the windshield going from the passanger side in the direction to the drivers side. Its 10cm longer now, than what is shown on the image. I will drive this car 1000km to its original country where the windshield will be replaced end…
user1721135
  • 291
  • 6
  • 11
1
vote
1 answer

1969 Toyota Land Cruiser brake bleeding order

i have a 1969 Toyota Land Cruiser with a single cylinder master cylinder and a single brake line that goes to the left front then goes to the right front then right rear then left rear. There are 2 wheel cylinders per wheel, one for each brake shoe,…
1
vote
1 answer

1989 Toyota land cruiser rear liftgate gas piston replacement

On my 1989 Toyota Land Cruiser, I need to replace the gas pistons attached to the lop half of the rear liftgate. How do I separate the gas piston from the body mounted ball socket? There is not any type of external clip to release so the piston will…
1
vote
3 answers

are toyota land cruiser's tires made of special material?

How is it that Toyota land cruiser can go to almost any road with big stones and sharp nails , etc and nothing happens to its tires. why? are its tires special and different from ordinary cars?
nobody7634
  • 11
  • 1
1
vote
0 answers

Unable to shift into low range when cold on my 100 series Toyota Landcruiser

It is impossible to shift into lo range when the vehicle is cold. I have changed the oil with no improvement. When the drive is warm there is not a problem.
Ron Couch
  • 11
  • 2
0
votes
0 answers

Why does my Toyota 3L engine won't idle and makes a metal scratching noise?

My Toyota Land cruiser manual transmission has just had the engine reconditioned: new pistons, piston rings, engine block, cylinder head, fuel injectors, fuel injector pump head, starter, fuel filter. But now it won't idle and needs to be helped to…
Don Lucas
  • 1
  • 2
0
votes
1 answer

brakes on 93 Toyota Land Cruiser HZ75 single cab

Have just replaced brake calipers on rear and piston kit in front calipers. Have bled brakes several times and no air but let pedal sit for a couple of seconds and then it pushes straight to the floor. Pump it up and hold it and it appears to hold…