2

The front washer jets in my Peugeot 206 (year 2000) have stopped working recently - the rear one is still working fine.

The vehicle is using a single twin-outlet pump to control back and front washers. The pump has a two-pin connection (GND, 12V) which, I believe, is inverted by the BCM depending on which washer is needed.

I have checked the most common issues:

  • The stalk itself is not the problem - pushing it down normally activates both the wipers and the washers. The wipers still go off when pressed.
  • It is not caused by clogged pipes - the motor does not engage for front washers.
  • The fuse is also fine.

After connecting a multimeter to the pump's cable, I have discovered that no power is delivered when the stalk is pressed down. When engaging rear washers, -12V can be observed.

How can I diagnose the problem further?

Bart Platak
  • 163
  • 1
  • 6

1 Answers1

1

This is a common problem I had with my 1998 Citroën Xantia, which uses the same sort of washer pump control. I turned out the pump motor was broken, probably a contact problem on the motor commutator. The whole replacement pump costs less than 10 € on the internet (new!). Give it a try.

EDIT: Oh, I just noticed I read wrongly: it's NO power delivered when you press the stalk. Sure?

Janka
  • 194
  • 4