1

Possible Duplicate:
How do I connect to a WPA wifi network using the command line?
Connecting to wireless networks from command line

I am a newbie to ubuntu 12.04.pls tell me how to connect to wireless network via terminal.I use a tata photon plus usb model.

How do i know that my internet is connected?(from terminal) I need to install,and update some packages.Somehow I couldn't do them through browser, because my system is running in low graphics.I need to fix a lot,for which i need to connect to internet.

Community
  • 1
user119463
  • 11

1 Answers1

0

First list your wireless devices

sudo lshw -C network

*-network
description: Wireless interface
product: BCM4306 802.11b/g Wireless LAN Controller
vendor: Broadcom Corporation
physical id: 0
bus info: pci@06:00.0
logical name: wlan0
version: 03
serial: 00:12:17:35:17:10
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=ndiswrapper+lsbcmnds driverversion=1.48rc1+Cisco-Linksys ,LLC.,02/1 ip=192.168.1.101 latency=64 multicast=yes wireless=IEEE 802.11g
resources: iomemory:3c000000-3c001fff irq:11

If the card is DISABLED it will show it. Run this command where eth0 is your network card

sudo ifconfig eth0 up

That command will turn on the wireless card.

VRU
  • 1,143