Introduction
Make sure you can explore the Xplod very well.
Tools
- 
                  
                  - 
            Press down the release button on the bottom left corner of the face plate. 
- 
            Then remove the face plate carefully. 
 
- 
            
- 
                  
                  - 
            Using the Phillips #0 Screwdriver, unscrew the 3 screws (length - 7.5mm) on the front of the device. 
 
- 
            
- 
                  
                  - 
            Using the Phillips #1 Screwdriver, unscrew the 2 thick screws (length - 7.69mm) located on both sides of the stereo. 
- 
            Remove side-metal plates gently. 
- 
            Use the Heavy-duty Spudger, insert the flat end under each of the black flaps indicated in the picture. Use leverage to pry and pop them loose. 
 
- 
            
- 
                  
                  - 
            Using the Phillips #0 Screwdriver, unscrew the 1 gold screw (height - 7.47mm) on the top of the stereo. 
- 
            Lift off the top plate. 
 
- 
            
- 
                  
                  - 
            Using the Phillips #0 Screwdriver, unscrew the 8 gold screws (length - 9.26mm), located on the back side of the stereo. 
- 
            Using the Phillips #0 Screwdriver, unscrew the 2 black screws (length - 13.27mm), also located on the back of the stereo. 
- 
            Using the Phillips #0 Screwdriver, unscrew the 1 gold screw (length - 9.3mm), located on the bottom of a hole as noted in pictures (2) and (3). 
 
- 
            
- 
                  
                  - 
            Using the Phillips #0 Screwdriver, unscrew the 2 gold screws (length - 7.34mm) found on both sides of the stereo. 
 
- 
            
- 
                  
                  - 
            Grip the top portion of the stereo, where the CD-Drive is located, and gently pull up to release it, but you will not be able to lift it all the way out. 
- 
            Grab the two tabs located near the back of the stereo, and gently pull the CD-drive front the rest of the device. 
 
- 
            
- 
                  
                  - 
            Remove the power supply on the circuit board. Please follow the iFixit soldering guide to assist you. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.