Introduction
Use this guide to replace the keypad guard on the front of the phone.
Tools
- 
                  
                  - 
            Find a flat head or Phillips head screwdriver. 
- 
            Insert the screwdriver into the holes in the plastic rod connecting the key pad guard to the rear casing. 
- 
            Use the screwdriver to push the rods towards each other until they click out of their locked position. 
 
- 
            
- 
                  
                  - 
            Slide off the antenna guard. 
- 
            Locate the four clips on the exterior of the rear casing. 
- 
            Simultaneously push the clips outward while lifting the rear casing and keyguard away from the front casing. 
- 
            Remove the old key guard from the rear casing by taking it out of its position. 
 
- 
            
- 
                  
                  - 
            Locate the circular extensions protruding from the top of your new key guard. 
- 
            Push inwards on the small tabs on the side of the protrusions until they are no longer sticking out. 
 
- 
            
- 
                  
                  - 
            Put the back case down on a table in front of you with the bottom of the phone close to you. 
- 
            Put the key guard's tabs into the corresponding tabs on the bottom of the rear casing. 
- 
            While the key guard's tabs are in the rear casing, put the rear casing's tabs into the bottom of the front casing. 
 
- 
            
- 
                  
                  - 
            To join the 3 pieces together, push the front and rear casing together so that the clips on the front casing lock into the holes on the rear casing. 
- 
            Slide the antenna guard on. 
 
- 
            
- 
                  
                  - 
            Locate the holes that connect the keypad guard to the rear casing. 
- 
            Find a thin and sturdy screwdriver. 
- 
            Insert the screwdriver into the holes in the plastic rod connecting the key pad guard to the rear casing. 
- 
            Use the screwdriver to push the rods away from each other until they click into a locked position. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.