Introduction
This simple guide will help you replace the display from your Lenovo T530.
Tools
- 
                  
                  - 
            Locate the latch located on the battery near the top of the laptop. 
- 
            Using your finger, slide the latch to the right-most (Unlocked) position. 
 
- 
            
- 
                  
                  - 
            You can now pull the battery away from the laptop. When pulling the battery out, ensure to pull it out straight. 
 
- 
            
- 
                  
                  - 
            Using a prying tool, such as a guitar pick, flathead screwdriver or your fingernail, peel the three covers highligted in red off. 
 
- 
            
- 
                  
                  - 
            Using a Phillips #00, take out the three screws highligted in red that were under the screw covers. 
 
- 
            
- 
                  
                  - 
            Using a guitar pick, flathead screwdriver, or your fingernail, stick your tool of choice in the gap between the bezel and the housing of the display. 
- 
            Pry the gap open all around the bezel. 
 
- 
            
- 
                  
                  - 
            Remove the four screws using a Phillips #00, there are two pairs of the two highlighted screws. 
 
- 
            
- 
                  
                  - 
            Remove any tape that is covering the ribbon connector, which is located at the bottom of the panel. 
- 
            Using your finger, gentlly disconnect the ribon cable. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.