Introduction
Prerequisite guide only! Pump rebuild steps before removing the pump from the motor housing. Written for the Karcher Pressure Washers 15209900 2018.
-
-
Use a pair of pliers to grasp the blue tab on the excess current valve.
-
Pull firmly to extract the excess current valve from the pump assembly.
-
-
-
Lubricate the replacement valve's O-rings with the grease included in the rebuild kit.
-
Press the replacement valve back into the pump.
-
Replace the cover plate with a new one from the rebuild kit.
-
-
-
Use pliers to grasp the tip of the fine filter in the water intake connector.
-
Pull the fine filter out of the intake.
-
Replace the fine filter with a new one from the rebuild kit.
-
-
-
Use a hammer and pin punch to tap the cylinder head plate out of its groove.
-
Remove the cylinder head plate.
-
To reassemble your device, follow these instructions in reverse order.
