Framework Laptop 12 Audio Board Removal

Written By: Arthur Shi
  • Comments: 0
Framework Laptop 12 Audio Board Removal

Difficulty

Easy

Steps

8

Time Required

5 - 15 minutes

Introduction

Audio Board removal prereq guide

  1. ENj2nRYJffBN2QaN
    ENj2nRYJffBN2QaN
    YjlDgdAsDVIlgqUJ
    GRNSY6XxqDVbUVQJ

    • Before you begin repairs, unplug your laptop and shut it down from the operating system. This ensures that the laptop isn't in standby/suspend mode.

    • The indicator LEDs along the edges should be unlit. The laptop should be silent.

    • If you accidentally turn on the laptop during repair, hold the power button down for 10 seconds to shut it down.

    • Make sure your Framework Screwdriver has the T5 Torx bit (labeled as T-5) facing outwards. If it's not, pull the bit out and flip it.

  2. ubIRwnfForMuSctD

    • Set your Framework Laptop face-down on a clean work surface.

  3. uSiaYQJxHWQEtBTp
    uSiaYQJxHWQEtBTp
    4PYD5BWmLBijnqFr

    • Use your Framework Screwdriver to fully loosen the eight captive T5 Torx screws on the bottom of your laptop.

    • Most screws in your Framework Laptop (including these) are captive—they're designed to stay in place after you loosen them.

    • Your laptop comes with a spare set of screws in the frame above the battery. Be careful—the replacement screws aren't captive.

  4. UomOMxHFjJlXOmVI

    • Flip your laptop over so it's face-up on your work surface.

  5. BAlEsafUboQ4NySF
    BAlEsafUboQ4NySF
    IOc5J3IPRwcuJcrW

    • Open the laptop lid so that both the screen and the base lie flat on your work surface.

  6. 1rUg25vLV4eVwDT1
    1rUg25vLV4eVwDT1
    PI4YlkgvqAGikOsI
    P4UYnHUqKXiVjnPu

    • Use your fingers to grip the Input Cover in the hinge cutouts.

    • Lift upwards to swing the Input Cover up from the base of the laptop.

    • There are magnets holding the Input Cover down, so you'll feel some resistance. If it feels like a lot of force is required, check that you've fully loosened all the screws on the bottom of your laptop.

    • Remove the Input Cover.

  7. 1LspFmdiEPudL3Zr

    • Use your Framework Screwdriver to loosen the captive T5 Torx screw securing the Audio Board along the left edge of the laptop.

  8. 6ipcMMTu1qUXBRPQ
    6ipcMMTu1qUXBRPQ
    bykbM2GttMpr464U
    tSWTJlYldWHuAX2M

    • Use your fingers to lift the right edge of the Audio Board and pull it out of its recess.

    • Remove the Audio Board.

Author

Arthur Shi

Member since: 03/01/18

296850 Reputation

0 comments