Diswoe Switch-01 Battery Replacement

Written By: Jonathan Bautista
  • Comments: 0
Diswoe Switch-01 Battery Replacement

Difficulty

Moderate

Steps

5

Time Required

15 - 30 minutes

Introduction

If you need to replace the battery of your Diswoe Switch-01 controller, follow this guide. Make sure it is disconnected from the console before you begin the repair.

  1. ajWTowymP1sW52vn
    ajWTowymP1sW52vn
    RRY126xHMJ6owXLW
    GOeM1YgWh5ObDTA3

    • Use a Phillips screwdriver to remove the two screws at the bottom of the hand grips.

    • Remove the handgrips from the controller.

  2. mVJLlLNc1tRUcRhG
    mVJLlLNc1tRUcRhG
    osxxwNsiZEikaVhS
    Ru3PNWPklRGSpmOR

    • Turn the controller over so the bottom is facing up.

    • Use a Phillips screwdriver to remove the five screws from the back case.

  3. FLO4JKbfTy6XFSAs
    FLO4JKbfTy6XFSAs
    SecHaMRZZrUFbRsD
    SbApMaLt3JFJejKt

    • Use both hands to carefully remove the back cover.

    • For help removing the back cover, use a spudger to pry along the seam between the top and bottom case.

    • Don't pull the back cover off quickly or forcefully as the wires that are connected are easy to break.

  4. EcDtTwSnBLftLA3o
    EcDtTwSnBLftLA3o
    glXYnUaiCe1KCXKJ
    FGRJqfQ3UDgkJLAt

    • Push on alternating sides of the battery connector to "walk" it out of its socket.

    • It may take a lot of alternating before the connector comes out. Be patient, and don't pull on the cables.

    • If that doesn't work, use a pair of tweezers to firmly grip the sides of the connector and pull straight away from the socket. Hold the tweezers closer to the connector to get a better grip.

    • Additionally, if the previous step didn’t work, use the arms of a pair of sharp tweezers to gently push the connector out of its socket by inserting them into the cutouts.

    • If you're having trouble, try rocking the connector side-to-side to loosen it.

    • To reconnect the cable, insert the connector into its socket and push on the edges until it's fully seated

  5. CwoB3MaDDCNHuQna
    CwoB3MaDDCNHuQna
    X2VGHHlfQoEsrRwB

    • Remove the battery from the main circuit board.

    • The battery is held in place by sticky foam. If you aren't able to remove it easily by hand, use a spudger to gently loosen the adhesive and then remove the battery.

Conclusion

To reassemble your device, follow these instructions in reverse order. Take your e-waste to an R2 or e-Stewards certified recycler.

Author

Jonathan Bautista

Member since: 25/09/24

251 Reputation

0 comments