Introduction
This guide will show how to add RAM or replace existing RAM on the Latitude D600
Tools
- 
                  
                  - 
            Find the panel underneath the microsoft product key sticker, the panel is labeled with an M 
- 
            Unscrew the single screw above the M 
 
- 
            
- 
                  
                  - 
            Pull off the panel to reveal the RAM 
- 
            RAM is held in by two tabs, pull each tab to the side and the RAM will pop up 
 
- 
            
- 
                  
                  - 
            To add or replace RAM, place the memory into the slot at an angle 
- 
            Make sure you line it up correctly 
- 
            If it is in correctly it should stay up at an angle by itself 
- 
            Then push down in the middle until it clicks into place 
 
- 
            
- 
                  
                  - 
            The RAM should be secured by the tabs where the two semi circles are on the RAM 
- 
            If it is not secure, just gently pull it out and try again, use the images to help you out 
 
- 
            
To reassemble your device, follow these instructions in reverse order.
One comment
Almost perfect: easy; clear;
Herman -